- Gyre Interface Module for 3K Pumps - IceCap
Hook up your IceCap Gyre pumps to most 3rd party controllers using an available 0-10 volt control port. Controlling Gyre pumps with a controller lets you create custom daily wave profiles, and also control your pumps through your controller's software.
Compatible with: IceCap Gyre 3K Pumps
When using the Neptune Apex (or other controllers) with the Gyre Interface module it allows complete control over the pumps at any point throughout the day. With simple visible graphing, controlling the Gyre pumps has never been this simple.
- Change the Gyre’s flow pattern multiple times a day
- Alternate pulsing frequency of the gyre
- Set operating modes like; feed, night, service, etc.
- Run IceCap Gyre in Alternating Gyre Mode (additional cable required)
- Battery Backup Compatible
- Neptune Apex Ready
Another great feature of the module is that it allows you to hook up your gyre to a backup battery. The module will automatically detect when main power is lost and will slow the gyre the 30% speed to extend the life of the battery.
Gyre Interface Module
Gyre Interface to Apex 0-10v Cable
Note: Interface module will control only one Gyre pump. Alternating Gyre Mode requires the Alternating Gyre Cable (sold separately).
There is a glitch By Rich on 12/27/2018Rich wouldn't recommend this product to a friendModules do allow you more flexibility over the native controller. However the modules reduce the power drastically. For example using the native controller at 100% vs the module and Apex at 100% is completely different. There is at least a 30% power reduction. I have been in contact with Coralvue for weeks now, they "reprogrammed" my modules but I saw no change once they were re-installed. I did find a few threads of people complaining about the same issue.
I have an Apex Lite, a VDM to control a Reef Octo Varios 8, an XF350 w/controller and avsecond XF350 pump. Do I use this to control XF350 pumps via Apex? What else would I need?
Unfortunately there is no current apex to 300 gyre interface yet. That module is for the IceCap 3k pumps not Maxspect.
Can the Apex JR be used with the gyre interface?
Thanks for reaching out to us. The gyre interface cable is compatible with the Apex jr., however, you would need the VDM module to give you the needed variable voltage ports. Let us know if you have any other questions. Thanks!