Loading...
Brightwell Aquatics

NitratR - Regenerable Nitrate Adsorption Resin 500 mL

In stock
Out of stock
SKU
209315
$43.87

$43.87
Discontinued by Bulk Reef Supply
- +

Overview

  • Next-generation regenerable nitrate adsorption resin effective in marine and freshwater aquaria; does not require soaking in buffered water prior to initial use.
  • Highly-selective for nitrate.
  • Will not negatively impact water quality, nor release nitrate once exhausted.
  • Synthetic polymer resin beads provide for durability and excellent flow characteristics; may be employed in fluidized-bed, canister, or passive filtration.
  • Regenerable over 250 times, dramatically increasing cost effectiveness.
  • Will not impact alkalinity in aquaria as some competing products may.

 

Instructions and Guidelines

Prior to first use, rinse each 500ml of resin by passing 4 quarts of fresh water through it in a steady stream; discard water once completed.

Basic
To initially lower excessive nitrate, each 500ml of NitratR will remove 20ppm nitrate in 100 US-gallons of water (or 10ppm per 200 US-gallons). When nitrate concentration remains unchanged or begins to increase, regenerate as described below.

Advanced
To a point, effectiveness of resin is directly related to the reaction time it has with aquarium water; the longer the reaction time, the more effectively it will remove nitrate. Once the nitrate concentration (”[NO3 -]”) reaches a nearly-immeasurable level, NitratR will continue to remove nitrate as it is produced in natural biological reactions. Remove and regenerate resin when [NO3 -] begins to increase, then reapply to facilitate continued nitrate removal. In all cases, the use of a mechanical pre-filter to remove particulate organic material from water prior to its interaction with this media will prolong effectiveness. Fluidized-bed filtration: follow instructions of filter manufacturer for optimal volume of media to use in reaction chamber; start at a low flow rate and adjust to keep media in a steady “churn” within lower 2/3 of chamber; flow rate should not be such that resin is ejected into aquarium. Canister filtration: Load resin into filter cartridge as directed by filter manufacturer; leave resin in place until [NO3 -] reaches desired level or remains unchanged, as directed above. Slowing the flow of water through the filter may be required to obtain maximum effectiveness of resin. Passive filtration: Place resin loosely in a 300μm mesh filter bag and locate in an area of lowto medium-flow. Turning bag over periodically during usage will serve to shift the resin beads and increases effectiveness of this method.

To Regenerate
Dissolve 4 cups table salt in 1 US-gallon of room-temperature water per 250-ml NitratR to be regenerated in a clean pail; place resin into pail and stir; allow beads to soak overnight; strain and rinse beads thoroughly in fresh water before re-using. Do not regenerate with bleach, which will damage resin and could kill aquarium inhabitants.

Caution
Keep out of reach of children. Not for human consumption

Note
Resin sold moist. Keep closed to prevent drying. Weight varies due to moisture content, therefore product is sold by volume rather than weight.

More Information
UPC 810086014293
Write Your Own Review
You're reviewing:NitratR - Regenerable Nitrate Adsorption Resin 500 mL
Your Rating
Only registered users can write reviews. Please or

Product Questions

No questions yet. Be the first to ask the question!