Os 1

Overview High-purity, magnesium-rich mineral that may be employed in traditional calcium reactors, or even blended in to pre-existing aquarium substratum, to gradually increase and maintain the magnesium concentration in the system. Provides magnesium, which helps regulate the balance between…

Overview Provides phytoplankton ranging in size from 1 - 2µm. Ideally-sized for many soft corals, clams, sponges, tunicates, tube worms, and larval invertebrates. Formulated to provide over 1-billion phytoplankton cells per ml. Does not require refrigeration. Supplemented with a proprietary…

…2 grams (~1 teaspoon) of Strontion-P in 8-fl. oz. of fresh water (preferably purified); each ml of the solution will increase the strontium concentration (”[Sr2+]”) in 1 US-gallon (3.785 L) of water by 0.75 ppm. [Reference: Each g of Strontion-P will increase the [Sr2+] in 1 US-gallon…

…purified); each ml of the solution will increase the potassium concentration (“[K+]”) in 1 US-gallon (3.785 L) of water by 1.7 ppm. [Reference: Each g of Potassion-P will increase the [K+] in 1 US-gallon (3.785 L) of water by ~129 ppm.] If initial [K+] in the aquarium is below 399 ppm,…

…oz. of purified fresh water; each ml of the solution will increase the alkalinity in 1 US-gallon (3.785 L) of water by ~1.0 dKH (0.375 meq/L). [Reference: Each g of REEF CDE B-P will increase the alkalinity in 1 US-gallon (3.785 L) of water by ~8.3 dKH (3 meq/L).] If initial alkalinity in the…

…contains no antibiotics or heavy metals. Over 50% stronger than competing products. Instructions: To prepare solution, add 1.0 ml (~20 drops) of MediCoral per 1 US-gallon (3.785 L) of seasoned aquarium saltwater in a clean plastic or glass container, then immerse coral completely as follows:…

…in 1 US-gallon (3.785 L) of water by 12 dKH (or 4.2 meq/L). Dosing Calculations For dKH: Multiply tank capacity in gallons x dKH increase desired x .089 = grams of product to add. Example to raise the alkalinity by 1.2 dKH in a 50 gallon tank the calculation is: 1.2 x 50 x 0.089 = 5.35 grams or 1…

…an accurate test kit. Add product to aquarium near a mechanical filter or protein skimmer intake at the maximum rate of 5 ml (1 capful) per 20 US-gallons daily for each 1 ppm of phosphate present in system. When used in this fashion, 250 ml treats up to 1,000 US-gallons (3,785 L). Add weekly at same…

…Aquatics Lugol’s will increase the concentration of iodine (“[I]”) in 1 US-gallon (3.785 L) of water by 34 ppm, or approximately 1.7 ppm per drop. Add this product at the maximum dosage of 1 drop (1/20th ml) per 35 US-gallons daily to maintain a concentration of 0.05 ppm. Always…

…water; each ml of the solution will increase the calcium concentration (“[Ca2+]”) in 1 US-gallon (3.785 L) of water by ~10 ppm. [Reference: Each g of REEF CDE A-P will increase the [Ca2+] in 1 US-gallon (3.785 L) of water by ~87 ppm.] If initial [Ca2+] in the aquarium is below 412 ppm,…

…Begin with 1g per 20 US-gallons in the system per week and adjust this ratio as conditions dictate. In high-nutrient aquaria, replace after 24-hours of total use; placement in lower-nutrient aquaria may be extended up to 48-hours of total use. Aquarist may choose to employ CARBONT-X3 for 1 - 2 hours…

…throughout the course of the week. Each ml of the solution will increase the calcium concentration in 1 US-gallon (3.785 L) of water by 2.50 ppm. [Reference: Each g of Calcion-P will increase the calcium in 1 US-gallon (3.785 L) of water by 95 ppm.] If the initial [Ca2+] in the aquarium is below 412…

…throughout the course of the week. Each ml of the solution will increase the calcium concentration in 1 US-gallon (3.785 L) of water by 2.50 ppm. [Reference: Each g of Calcion-P will increase the calcium in 1 US-gallon (3.785 L) of water by 95 ppm.] If the initial [Ca2+] in the aquarium is below 412…

…throughout the course of the week. Each ml of the solution will increase the calcium concentration in 1 US-gallon (3.785 L) of water by 2.50 ppm. [Reference: Each g of Calcion-P will increase the calcium in 1 US-gallon (3.785 L) of water by 95 ppm.] If the initial [Ca2+] in the aquarium is below 412…

…between NoCarbont-Z and aquarium water (e.g. the slower the flow of water through the media), the more efficiently NoCarbont-Z will perform.Begin with 1 g per 20 US-gallons in the system per week and adjust this ratio as conditions dictate. In high-nutrient aquaria, replace after 48-hours of total…

…Store tightly closed in a cool dry location. For best results, shut down pumps. Mix one level scoop (use enclosed scoop) of powdered food with 1 to 2 ounces of filtered water. Use a syringe to target feed or broadcast feed, as desired. Do not overfeed! If you desire to fortify the mix, you…

…and nutrient-assimilation. Thereafter, switch to “low-nutrient” dosage (below).Low-nutrient Systems: Add 5 ml (1 capful) per 100 US-gallons (378.5 L) [≈1 drop per gallon (3.8 L)] of aquarium water daily. With time, hobbyists may determine that decreasing the dosage and/or dosing…

…purified water and ultra-high purity materials. Formulated by a marine scientist. Instructions and GuidelinesBasic: Shake well before using. Add 5 ml (1 capful) per 25 US-gallons of water in the aquarium system weekly for the first four weeks of use; then, gradually increase the dosage to 10 ml per…

…before feeding, enabling adequate time for the vitamins to become thoroughly absorbed by the food. Liquid food suspensions may be fortified by adding 1 ml (approximately 8 drops) Vtamarin-M per 10 ml of food suspension; stir to mix and allow 5 minutes to elapse before feeding. Maximum benefit of any…

…to Canada Feeding Guidelines Store tightly closed in a cool dry location. For best results, shut down pumps. Target feed individual polyps by using 1 to 2 pellets per coral. For large corals, you can add more if desired. Can also be used to feed fish and shrimp. For smaller polyps, you can break the…

…only as directed.Basic: Add 1 ml (~20 drops) per 25 US-gallons (94.6 L) every three days (alternatively, twice a week). If using the product in a particularly small aquarium (e.g. ≤ 10 US-gallons), dilute 1 ml of KoralColor in 8 fl. oz. of purified water and add 1 fl. oz. of the resultant…

…no unwanted organic material such as EDTA, gluconate, or polygluconate. Instructions and GuidelinesBasic: Shake product well before using. Add 5 ml (1 capful) of product per 20 US-gallons of aquarium water every other day or as needed to maintain the magnesium concentration within a range of 1,290 -…

…quickly can have a negative impact on these organisms). Subsequent dosage of the media can be increased on a weekly basis to a final ratio of ~1 g per 1 US-gallon. Each isolated aquarium system will have different requirements, and the most efficient use of this media will rely upon regular testing…

…rubber gloves & goggles when handling! Professional Strength, do not overdose! Add 30 drops or 1.5 ml of Koral MD Pro Professional Coral Dip to 1 gallon (3.8 liters) of aged seawater (preferably old aquarium water) in a plastic container. Mix well. Place the coral in the mixture. Make sure the…

…tube with hot water and soap. Alternately you may soak the dropper tube in hydrogen peroxide to disinfect it. Target Feeding (recommended): Pour 1 ml (~20 drops) into a small container and suck a portion into feeding device, then slowly discharge contents 2 - 4 upstream of the target organism(s).…

…before feeding, enabling adequate time for the vitamins to become thoroughly absorbed by the food. Liquid food suspensions may be fortified by adding 1 ml (approximately 8 drops) Vtamarin-C per 10 ml of food suspension; stir to mix and allow 5 minutes to elapse before feeding. Maximum benefit of any…

…pour water into the aquarium system, then place Xport-NO3 into canister filter, media reactor, or 800µm mesh filter bag; a flow-through rate of 1 - 3x the total aquarium volume per hour is recommended. Do not fluidize. In systems with an initial [NO3] of <40 ppm, begin with a ratio of 150 g…

…organic material. Removes copper from medicated systems. Removes lead and other heavy metals. Completely Reef Safe Available in Five Sizes 250 mL 500 mL 1 Liter 3.8 Liters 20 Liters Instructions and Guidelines Prior to first use, rinse Puritunder a stream of fresh water, then discard water. *Used as…

…Separate the portion of the live food (such as rotifers, daphnia, brine shrimp, etc.) and place them in a clean vessel without water circulation. Add 1 drop Aminmega per quart of water in the vessel and stir gently to disperse the droplets throughout, then allow 20 - 40 minutes for the organisms to…

…to dose; rather, you must rely on the appearance of the livestock to make that determination. We encourage new users of this product to dose 1 ml per 10 US-gallons weekly for the first four weeks of use; this corresponds to dosing 0.14 ml (~3 drops) per 10 US-gallons each day. Then, gradually…

…bottle caps are 5 ml. Shake well before using! Day 1: add 2 ml ( capful) Day 2: add 5ml (1 capful) Day 3: add 7 ml (1 capfuls) Day 4: add 10 ml (2 capfuls) Day 5: add 12 ml (2 capfuls) Day 6: add 15 ml (3 capfuls) For maintenance, add 7.5 ml (1 capfuls) every other day or as needed. Activated carbon…

…before feeding, enabling adequate time for the product to become thoroughly absorbed by the food. Liquid food suspensions may be fortified by adding 1.0 ml (approximately 8 drops) Garlic Power per 10 ml of food suspension; stir to mix and allow 5 minutes to elapse before feeding. Maximum benefit of…