- Home /
- Air Filled Pressure Gauge 1-100 PSI
-
BRS 4 Stage Value RO/DI System - 75GPD
129 Reward Points$129.99 As low as: $123.99 -
Auto Shut Off Kit for Reverse Osmosis Systems
24 Reward Points$24.99 As low as: $23.99 -
1⁄4" Aquatec 8800 Booster Pump Kit
139 Reward Points$139.99 As low as: $132.99 -
Mur-lok RO Inline Ball Valve Push Connect
Starting at: $5.99
-
Must have for any rodi unit By Anthony on 4/12/13
Anthony would recommend this product to a friendNot only is is easy to install but is beneficial for proper use of your unit to determine if new filters are needed by pressure dropping lower than average -
Wonderful By Timothy on 9/10/12
Timothy would recommend this product to a friendNo complaints. Get's the job done and let's me know what the pressure is going to my BRS RODI unit. -
Good tool to have By Jeffrey on 7/4/12
Jeffrey would recommend this product to a friendI have this installed right before the RO membrane and tells me the PSI of source water going into the membrane. If the pressure drops too low than average then that would tell me if there is a clog/damaged hose line or either sediment, carbon, chlorplus are in need of a change. -
Perfect! By moore1811 on 5/25/12
moore1811 would recommend this product to a friendI wanted to see how much psi my booster pump was pumping up prior to the RO/DI unit and this was all I needed! Accurate and easy, it installed in seconds! -
Know your pressure By Brad on 4/26/12
Brad would recommend this product to a friendUse this to verify pressure to my BRS RO/DI unit. Works great and is easy to read. -
Works Well By David on 3/26/12
David would recommend this product to a friendNo complaints. Get's the job done and let's me know what the pressure is going to my BRS RODI unit. -
good for light duty By Rob on 2/22/12
Rob would recommend this product to a friendBought this to test the pressure in other water lines (pump driven) as well as a backup for my RO. I feel like it's good for taking out and using for 'sanity checks', but if I were hooking it up permanently I'd probably go for the glycerine filled one instead. -
Simple, and low cost! By Crow on 10/22/11
Crow would recommend this product to a friendI ordered one because I wanted to make sure my water imput was high enough for the 150g RO upgrade I did on my system. After having some issues, I called BRS up and they had me going within mins! A++ -
Affordable way to know your household water pressure By Keith on 2/28/11
Keith would recommend this product to a friendBought the 150gpd water saving kit and although the efficiency of my RODI unit significantly increased, I thought that it was a little below par, so I added this and found out that I need a booster pump. Great product, and not available at any hardware or plumbing supply stores in my area -
Great for the money By Joyce on 2/14/11
Joyce would recommend this product to a friendI ended going with this over the glycerin filled one due to the price. It was a bit jumpy when I had it connected around my booster pump. After moving it closer to the RO membrane it is perfectly steady. You may want to opt for the glycerin filled depending on your placement.
Either way, a pressure gauge is a great thing to have on an RODI system. If you don't have the proper pressure you could be getting far less output than what it's rated for or you could be damaging it by too much pressure. -
a must have By jimmy on 2/3/11
jimmy would recommend this product to a friendworks great every time , good buy -
Good enough! By Zeph on 7/29/10
Zeph would recommend this product to a friendI opted for the air-filled gauge because it was cheaper, no complaints! It doesn't jump around and saves a little money, I would recommend this product as a good value. Having a gauge makes it a lot easier to see what's going on with your system.
-
RO Upgrades-Pressure Gauges, Meters, and Flush Kits
Pressure gauges, flush kits and TDS meters are eas ...
More11043 Views
Ask a Question About 'Air Filled Pressure Gauge 1-100 PSI '
Previously Asked Questions
No questions have been asked yet.
Sufficient PSI is very important for the correct operation of a reverse osmosis unit. Low water pressure is a leading cause of poor RO system performance. A pressure gauge assures that proper pressure is being supplied. It will also make pressure drops apparent which can tell you that sediment and carbon blocks need to be changed.
This air filled pressure gauge comes assembled with 1/4" quick connect fittings for quick easy installation in-line before the RO membrane.
-
Deal of the Day!
BRS 5 Stage RO/DI System - 75GPD
Ends inRegular Price: $159.99
Special Price: $149.99
00:00:00:00
-
FREE PRIZE$
-
Bulk Media & Additives
-
Bulk Reverse Osmosis Filters & Systems
-
Bulk Dry Live Rock & Live Sand
-
Aquarium Additives
-
Auto Top Off Systems
-
Filter Media
-
Fish & Coral Foods
-
Fragging Supplies
-
Heaters & Chillers
-
Lighting
-
Medications & Pest Removal
-
Monitors & Controllers
-
Plumbing
-
Protein Skimmers
-
Pumps
-
Reactors
-
Sumps, Tanks & Refugiums
-
Tank Maintenance & Salt Mix
-
Testing
-
UV & Ozone
-
Videos & Books
-
Specials
-
Clearance
-
New Products
Send us your feedback
Let us know.
Company Info
Phone: 763-432-9691
Fax: 763-546-1720
Hours: 9am -5pm CST M – F

Email: support@bulkreefsupply.com
672 Mendelssohn Ave N, MN 55427 Map

