O-Ring for 10" Reverse Osmosis Canisters

SAVE
$0.30
O-Ring for 10" Reverse Osmosis Canisters
Click on image to zoom
View full size image

More Views

  • O-Ring for 10" Reverse Osmosis Canisters
  • O-Ring for 10" Reverse Osmosis Canisters in package
  • O-Ring for 10" Reverse Osmosis Canisters side shot

O-Ring for 10" Reverse Osmosis Canisters

SKU: 200904
Performance
13 Review(s)

reg. $1.99

Special Price: $1.69

Please wait...
OR
  • The perfect cure for my stupidity By on 4/26/2017

    I purchased several of these O-rings to replace the originals that I stupidly wore out early by not adding the Dow Molykote 111 to the shopping cart!! Everyone knows that soft rubber sticks and yet I "assumed" I did not need to protect the O rings from sticking. Big mistake. These O-rings are perfect replacements for the ones on my 150 gpd brs RO/DI unit!!!
  • Does its job! By on 3/8/2017

    Our 6 stages RO/DI came without one of these rings and my husband and I tinkered for a while trying to figure out why we had a dripping leak.
    ...which is entirely silly since we had a replacement O-ring on the way within a few hours of finally emailing BRS support (duh!). We weren't in a hurry getting set up though, so it wasn't a big deal and totally our fault for not catching sooner! Very happy and impressed!
  • Not the same size By on 1/5/2017

    My small BRS reactor started leaking and I did not see a o ring specifically for the small reactor. I emailed service and she had me order this o ring. it is much thinner than the original and appears to be a touch smaller. I installed it and sure enough it did not stop the leak. I made sure not to over tighten the canister. I'll need to contact service again.
  • Just what I needed By on 12/3/2015

    This is a perfect fit for the BRS Deluxe Reactor. Works great.
  • works great By on 9/9/2015

    The o-ring came in within two days. I put it right in and it was a perfect fit.
  • brs reactor o ring By on 2/6/2015

    these work great if your brs standard reactor o rings are getting old. I was having to really over tighten the reactor to make it seal, but after replacing them I can go back to hand tight or so.
  • Works By on 1/31/2015

    Does what it's supposed to for the size its designed for.
  • Works Great By on 12/14/2014

    I had to replace one of the o-rings on my new value ro/di unit. I couldn't find the exact size of the one that came in it anywhere locally. These are the ones you need. They're cheap. They work. I can't complain.
  • slow leak By on 11/16/2013

    I have a very high pressure 95psi water line. While these o-rings seem to work okay when new, by the time you replace the filter cartridges you will notice that they have become bit squared. I have measured these to be 85mm ID by 4mm CS. My solution is a #340 standard, 70 duro, FDA approved, EPDM o-rings that I bought from an online o-ring store. The size is slightly bigger than this o-ring but works perfectly, 3 3/8"ID by 3/16"CS. Now I don't have to over tighten to get a perfect seal. FYI, I bought my 5 stage plus from BRS in July 2012 so I'm not sure if I have the old model.
  • Too small By on 9/23/2013

    I had to return the O-rings as they were not the correct size. The O-rings do not fit the older RO canisters