DIY: 2 Part Dosing Containers | How To Tuesday

December 23rd, 2014
For just over $10, you can make your own 2 part dosing containers using just four items.

Here's what you need:
(2) 1/4" acrylic tube
(2) Mur-Lock bulkheads
3/4" Drill bit

Step 1: Drill a hole in your containers cap or lid. We used a stepper bit and our Mr. Chili Mixing Jug (which is a standard 1 gallon jug, you can use any container with a cap or lid).

Step 2: Insert bulkhead into your drilled hole and screw on the nut.

Step 3: Cut your tube to the appropriate length for your container and insert into the bulkhead. Be sure it goes in all the way, and that the seal is tight.

Step 4: Screw on the cap

Step 5: Drill a small hole in your container allowing air to escape (this way you will not be creating a vacuum when sucking fluid out).

That's it! The container is nice because the tube stays a consistent distance from the bottom and the dosing pump tubing is connected securely.

If you have any questions about this project or suggestions on how to make it better checkout the comments area down below

Like this video? Subscribe! We release new videos every Tuesday and Friday.

Connect with us on Facebook:

Check out our pics on Instagram: