Product Description
Self Piercing Saddle Valve Installation Instructions
- Choose a location as close to the RO unit as possible.
- Make sure the water supply is OFF.
- Back up the piercing pin all the way by turning the handle counterclockwise. It should be retracted slightly past the rubber gasket.
- Position the valve over the pipe and turn the loose clamp piece appropriately to fit the shape of your pipe.
- Firmly snug the valve to the pipe by turning the screw/bolt. This should be done by hand to avoid over tightening.
- Slide compression nut on RO tube.
- Slide on compression sleeve. Note that the sleeve is narrower on one end. Narrow end should be away from valve.
- Insert brass insert into tubing end.
- Tighten compression nut to valve to attach tubing. Do not over tighten.
- Slowly turn valve handle clockwise to pierce pipe. Turn it all the way. This is the "OFF" position.
- Back the valve handle out to open.
- Turn on water supply and check for leaks.
You may also be interested in the following product(s)
|
Glycerin Filled Pressure Gauge 1-100 PSI
$18.99
As low as: $15.20 |
150 GPD Water Saving Upgrade Kit
$59.99
As low as: $54.00 |
FM-2: Filter Monitor with Volumizer HM Digital
$49.99
|
Leak Controller/Detector for RO/DI Systems
$44.99
|
Product Tags
Add Your Tags:
Use spaces to separate tags. Use single quotes (') for phrases.
Questions on Self-Piercing Saddle Valve 5/8" Pipe
No questions asked yet
Loading...