Product Description
Uni-Seal Installation Instructions
- Cut hole to the hole saw size indicated for the UNISEAL above.
- Insure that the hole is clean with no sharp edges. Irregularities can cause a poor seal and leaks.
- Insert the UNISEAL into the hole with the wide flange on the outside of the container.
- Insure the pipe end that will be inserted is clean of burs or sharp points. File the edges if needed.
- Insert the pipe into the Uni Seal. You can lubricate the pipe end with Windex. Most of it will be squeezed off during installation but be sure to wash thoroughly before turning on your system.
You may also be interested in the following product(s)
|
1” SCH 80 Bulkhead Slip x Thread (Slip on the Flange/Head side)
$7.99
As low as: $7.20 |
1” ABS Bulkhead Slip X Thread (Slip on the Flange/Head side)
$5.99
As low as: $5.40 |
16 Piece Hole Saw Drill Bit Set
$19.99
|
1” Schedule 80 Cepex Ball Valve
$22.99
As low as: $20.70 |
Product Tags
Add Your Tags:
Use spaces to separate tags. Use single quotes (') for phrases.
Questions on 1" Uniseal Bulkhead Alternative
No questions asked yet
Loading...