MAKES MAKING RODI FASTER By Tom on 8/12/2012
Tom would recommend this product to a friend
I bought this because I am on a well with 35psi, with this booster pump I now have 90 psi. This pump along with the 150gpd upgrade kit I am getting great results. I run it 6-8 hours at a time and it barely gets warm. A bit pricey but works great..
nice little pump By Tony on 8/5/2012
Tony would recommend this product to a friend
My system is in a finished basement and I can barely hear it when it kicks on. It does a grat job. I have been using it now for aboput a month
overdue By Carlos on 7/22/2012
Carlos would recommend this product to a friend
I have three RO systems my main aquarium water system has two 75 GPD membranes that produce a total of 150 GPD. I have good water pressure but I wanted good control. Typical RO systems with mechanical ASO valves are extremely unreliable. With this system using a booster pump and a pressure switch and an added normally closed 24V solenoid make it extremely reliable for my application. The pump is extremely quiet and produces a lot of quality water my TDS before the booster was 7-16 PPM and now it is 5-7 PPM before the DI stage. I fill my 25 gallon container in about 3 hours so I'm actually producing over 150 GPD (200 GPD). I also have a system using a 6800 booster pump and I have to say this pump is a huge improvement. I strongly recommend using a 24v Solenoid if you are using a float switch way over an ASO. Great value great performer the kit really needs to include a solenoid to shut the water to the membrane for that added security. I found that my ASO often turned on after the tank was full wasting water to drain I guess all I can say is an ASO valve is better than nothing.
Keeps Production Going By Pet Store George on 7/18/2012
Pet Store George would recommend this product to a friend
I have a dog groomer in my pet shop and before I got this pump, my RO production would shut down when the grooming was bathing a dog. With this pump, I can keep producing all day long at a constant rate. This has helped me a lot.
What a difference By Jbkilg2 on 7/15/2012
Jbkilg2 would recommend this product to a friend
Great addition to boost my ro/di output. Out of the box easy install too! I have low pressure and this quadrupled my water that had been very slow.
Great addition By Brandon on 7/14/2012
Brandon would recommend this product to a friend
I added this pump to my 150gpd ro and my tds went down and my water production went up.
Great product, increased my water production greatly By Jared on 7/8/2012
Jared would recommend this product to a friend
Up until recently I relied on my household water pressure to run my RO/DI system. At only 40-55psi max it would take roughly an hour to make one gallon of product water. I made this purchase and have never looked back; I can't believe I waited so long for this. I have been running my system for almost 2 years before I made the leap and purchased the booster pump. I have went from producing 1 gallon an hour to 3.5 an hour. The waste water volume has also reduced along with the time interval it takes for my DI resin to exhaust. The volume of water that used to take me two and almost 3 three days now takes less than one. I can't express how delighted I'm for this product.
Well worth the money By Terry on 5/31/2012
Terry would recommend this product to a friend
I had to get this because our water pressure was only around 26lbs.
So glad we did! The only issue i had with it. Was the vibration, it would shake the water line pretty good. Which I solved by placing some foam tubing over it.
Great Pump! By moore1811 on 5/24/2012
moore1811 would recommend this product to a friend
Although a tad pricey for my taste I happy with the quality of the product. It did it's job and boosted my very poor water pressure to a hefty 75psi with no problem. Now I can use the 150GPD upgrade with maximum efficiency.
Must have pump By Ben on 4/12/2012
Ben would recommend this product to a friend
Recently added this pump to my 5 stage RO/DI with dual 100 GPD membranes and I had pretty decent pressure at 60 PSI, but I added this and wow did it make a difference. I now make water at almost 270+ GPD a day. 40 gallon tank is filled in 3 1/2 hours!!!!
great pump By Clinton on 3/22/2012
Clinton would recommend this product to a friend
This pump is soo nice. Since Im on a well and my water pressure was to low my ro unit was not running efficiently. But now its running great. I would recommend a prefilter so you don't ruin the pump
great efficiency addition By Byron on 3/21/2012
Byron would recommend this product to a friend
we're now on a well with marginal pressure -- this (pricey) booster brought our efficiency up a bunch!!!!! wish it was cheaper, love what it does for me...
Works amazingly well with AWI Typhoon RODI By Shawn on 2/23/2012
Shawn would recommend this product to a friend
I have the Air Water Ice Typhoon Extreme III RO/DI system. It worked *ok* on city water pressure around 35-40psi. I've since moved to my new house where my well water pressure is only around 25psi and the RO/DI output is awful. Admittedly, I needed to change the RO filters, but it took THREE hours to fill a 5 gallon bucket….Three hours!!! I knew a booster pump was definitely needed.
I was considering the pump that AWI sells, but heard mixed reviews so I tried this one given the great reviews here and on all the saltwater forums. I’m glad I did!!! This baby is sweet. Super easy to setup and the pressure switch works perfectly for shutting off the pump when my ASOV kicks in. You can barely hear it running too.
The AWI RO/DI I have says that you shouldn’t go above 75psi so I was able to fine tune the pump (using adjustment screw on top) to give me 70psi and the water production rate is SO much better. The most satisfying test is just turning the pump off and seeing how pathetic the flow rate into your holding container is! Then plug it back in and watch the water start streaming out!
The rejection rate also seemed to get better too. I don’t have exact percentages because I forget what my well water TDS was to start with…but I can say that my TDS out of the RO membrane fluctuates between 1 or 2 WITH the pump. Without the pump, I was getting 4-6 pretty consistently. Naturally it is 0 out of my DI…but the lower the TDS is on the input to the DI, the less money you pay in DI replacements!
AWESOME!!! A MUST FOR LARGER RODI SYSTEMS By spotter on 2/20/2012
spotter would recommend this product to a friend
I just added this to my system when I upgraded from 75 gpd to 150 gpd. My pressure was just under 55 psi and I split my rodi output line in 3 different directions. I would never be able to fill 3 different containers at the same time...until now that is. With the booster pump my psi gauge is full throttle and I can fill all 3 containers at the same time when needed. You won't regret this investment.
Well worth the investment! By Collin on 2/17/2012
Collin would recommend this product to a friend
Before I installed this my house was pressurizing the input at 45psi which ended up meaning that the RO/DI 5 stage was producing 37 gallons per day, way below optimum.
After installing the pump I was producing water at 72 gallons per day, extremely close to the touted 75 GPD for the RO/DI sold on BRS.
See my full review with pictures at:
Great addition to RODI system By Kevin on 2/16/2012
Kevin would recommend this product to a friend
I had an inlet pressure of 42 psi. I added this kit and my inlet pressure went to 94 psi. It makes RODI water fast and it is relativly quiet. easy to install and use. Worth the money
Able to expand with Aquatec 8800 By Jim on 1/29/2012
Jim would recommend this product to a friend
My faucet pressure is only 22psi and when I first installed this pump I was getting 92psi to the membrane! I easily adjusted the pressure to 63psi. I would'nt have believed the improvement with my 75gal 5 stage+ if I had not seen it for myself. The pump is also very quiet running even though I run my system on the countertop.
Great unit but be ready to adjust By Doug on 1/22/2012
Doug would recommend this product to a friend
Watched the video for installation and BRS said the pump and pressure switch are adjusted from the factory so no adjustment is usually necessary. I hooked everything up and the booster pump went over a hundred psi so I had to back it down. Then tested the pressure switch and at about 90 psi it was still going strong so I had to adjust that as well. Now that everything is adjusted properly its working like a charm. Love it!
Low Pressure Problem Solved By Keith on 1/17/2012
Keith would recommend this product to a friend
I ordered this item and it arrived today. It only took about 20 minutes to install. I oredered it due to the low pressure coming into my home. I was getting 30 psi at best. After installing the booster pump, the pressure jumped to 80 psi, making my system more efficient. I highly recommend this item for those dealing with low water pressure. It works as discribed, easy to install and runs quietly.
excellent booster By Jose on 1/9/2012
Jose would recommend this product to a friend
previously had little water pressure. Now I have nothing to worry about water pressure, easy installation, low vibration, making the most advantage of my system of RO / DI.
boosted up By Andrew on 1/6/2012
Andrew would recommend this product to a friend
Kit is great with everything you need to complete the setup, had a bit of a draw back since it blew the lid off of an aditional canister so i BACKED IT DOWN A BIT. wAS RUNNING HOUSE PRESSURE AT 35-40- NOW AT 70-75.
Have a well -- get this pump By Carveth on 12/1/2011
Carveth would recommend this product to a friend
It is nice for everything you need comes with it and their video makes for an easy install. We have a well and I thought I'd try the RO/IO system without it. No go. Wells are set up with lower pressures and varying pressures. They typically operate between 30 - 50 pounds, give or take a few pounds either way. The lower pressure is to reduce the back pressure on the pump down in the bottom of the well. This makes it last much longer. The range also saves the pump. Otherwise the pump would have to come on every time you turn a faucet in the house. It would be constantly kicking on and off. The well pump, pumps water up into a pressure tank which keeps a steady flow throughout the house.
Well worth the money By Adam on 11/29/2011
Adam would recommend this product to a friend
I have a well so I had very low water pressure. Now I get over 90psi and my 5-stage plus unit produces water much faster.
Increased RO water output! By David on 11/11/2011
David would recommend this product to a friend
Well worth the cost. With this pump my RO system puts out 30-40% more. Easy cost savings and easy to install.