works great By Ed on 11/7/2013
Ed would recommend this product to a friend
I have about 37 psi out of my faucet, and made 1 gal about a half hour or more , now it's at 80 psi and 1 g a l in. About 15 minutes. My concern is that the Gage was going up to 90 psi as. I went along making water. I turn it down to 60. I don,t know which numbers I should watch, the outer numbers or the inner ones ?? Otherwise I'm very satisfied.
A must have By Sven on 11/7/2013
Sven would recommend this product to a friend
My Tap water pressure was running about 40 PSI. Ever since I bought this and adjusted my PSI to ~70 PSI I now produce product water 2-3 times faster... and my DI Resin lasts longer as well!
Works great By Chuck on 11/4/2013
Chuck would recommend this product to a friend
This is just what I needed. I had a little over 37psi before I added this pump. I am now running at about 80psi now. Works great.
Great Investment to a RODI system By Kha on 11/2/2013
Kha would recommend this product to a friend
I had 45psi on my 75gph + 150gph upgrade RODI system until I added this pump. My psi is now 82-ish. Working great so far! Very easy to assemble and BRS already has a video on the installation (not that you would really need it). The pump makes some noise (very little) and vibration as all pumps do. The bracket seems to help out a bit. Not very concerned about the noise level since its going to be installed in a basement/ garage area. Wished the transformer had mounting hardware for the wall as the RODI and booster pump does. It has 4 rubber feet that sits on a horizontal surface. Not a big deal and not worth dropping any stars.
A MUST HAVE!!! By Megan on 10/18/2013
Megan would recommend this product to a friend
A must have!!! Nice to see the water quicker!! Life saver
What took me so long! By Turf on 10/15/2013
Turf would recommend this product to a friend
This is awesome, consistent 80psi to my filter so everything works unbelievably better, faster and more consistent. Wish I bought this years ago.
Stop what you're doing and BUY THIS UNIT NOW By Carlos A. on 10/6/2013
Carlos A. would recommend this product to a friend
I've been frustrated to no end trying to fine tune a similar setup I bought from another vendor. Their unit included the same pump but didn't include a pressure switch and instead required the endless fine-tuning of several different variables (turn this dial down, turn the other up, but not too much, etc...), which took hours and hours and it never ever came even close to working as well as this did right out of the box. This is a set-it-and-forget-it solution that is SO MUCH EASIER. I had thrown away my previous set up and I am so glad I bought this one. My 150 gpd RO system went from producing a very slow drip (maybe 25 gallons/day) to now producing a solid stream of very close to the 150 gpd max. More importantly, the ratio of good to bad water is much better. Buy this now. It's the same kind of quality you find with Tunze and Bubble King.
I highly recommend combining this with the: Aquatec Auto Flush Flow Restrictor, also available on this site. That makes it truly an automatic system that will save you tons in filters and water over the long run.
Aquatec is brilliant for having designed this. Bravo.
excellant value and a must have time saving pump By happy reefer on 10/6/2013
happy reefer would recommend this product to a friend
llike everyone else I had low psi only 40 going into my 5 stage brs ro/di unit and only making 2 gallons of water at about 35min a gallon and replacing resin at a quicker rate then I would think should be needed so my descision became a cost saving idea to finally purchase so I lucked up it just so happen a fellow Michigan reefer was selling one for $70 with power supply and pressure switch so it was a no brainer when I offered a trade and only spent $50 and with the rubber feet you cant really here it running I went from psi of 40 to 60 and with the adjustment screw I now have 80 psi and producing 1 gallon every 15-18 min 0 tds water
Great Product By Brian on 9/10/2013
Brian would recommend this product to a friend
I was ripping through DI resin like crazy. With the addition of this pump, I get much more life out of my resin.
A must for any RODI system By Timothy on 9/3/2013
Timothy would recommend this product to a friend
The Aquatec 8800 booster pump is a must for any RODI system. I had adaquate water pressure half of the year before adding the pump- now I am making water at my systems capacity more efficiently even in the winter. The pump will pay for itself over time and is easy to integrate into your current system.
Problem Solver! By Mark on 9/1/2013
Mark would recommend this product to a friend
Water pressure out of the tap was 25-30 psi. Not good, Ordered this kit from BRS and now I'm at 63 psi with plenty of room to spare. Problem solved and the best price.
A must if you have your own well By Tom T on 8/7/2013
Tom T would recommend this product to a friend
I live in the country with my own well. I connected my RO/DI system and the pressure swing between 24 and 32 psi. I added this pump and now my pressure is between 88 and 90 psi. This has increased the my RO/DI water output tremendously.
Need a boost By Little man on 8/6/2013
Little man would recommend this product to a friend
I got the aquatec 8800 kit from brs I hooked it to my brs ro di system and what a difference it made . My water pressure went from 35 psi to 95 psi . Also my brs di resin last longer now. I also got the pressure switch and float valve which took the guess work out when my water storage container was full . No more check every hour to see if it is full. It shuts the pump off automatic when it reach a certain level. Thanks brs for making reefing easier
Pricey investment that's worth every penny. By Jeffrey on 8/4/2013
Jeffrey would recommend this product to a friend
I was running 40psi with my 75gal ro system in my apt. adding this pump with the 150 gal upgrade, I couldn't be happier running at 80psi and using up less resin than before. Someone like me who doesn't have a lot of time to spend making ro water this gets the job done quickly.
Must have for low pressure By Aaron on 6/29/2013
Aaron would recommend this product to a friend
Having well water only gave us a maximum of 45psi and dropped to around 30psi before the well pump kicked in. Water production was horrible and waste ratio was 4:1. With this pump we are at a consistent 85 to 90 psi and waste ratio has improved significantly. This pump is a must have for well owners. Hook up was easy, although I placed the pump right before the membrane instead of the first sediment filter. Works perfect.
booster pump By Billy on 5/30/2013
Billy would recommend this product to a friend
If you ain't got a booster pump for your ro system you need to get one. Talking about putting out good amount of water.
Works Great By Tom on 5/20/2013
Tom would recommend this product to a friend
I didn't have enough pressure for my RO system. Very easy to install and now I'm getting all the water I need.. Works great!
Awesome in almost every way, maybe a little loud By tramboneplayer5 on 5/18/2013
tramboneplayer5 would recommend this product to a friend
My 75GPD 6-stage chloramines RO/DI kit was more like a 35-40GPD system until I got this pump. Water used to trickle out so slowly. The TDS going in to the DI stage was high as well and I was tearing through DI resin like crazy. When I added this pump, I had to turn it down a little to get back to 80psi by using the small hex screw in the center of the top and turning it counter-clockwise. Water shoots out so much faster (80-90GPD) and the TDS is lower out of the RO stage. The only mistake was mounting this to a wall - the vibration is carried through the house and it makes it pretty loud. I will try moving it to another surface that is de-coupled from the wall.
Does the job By den75 on 5/12/2013
den75 would recommend this product to a friend
Excellent pump. PSI went from 32 to 85 immediately increasing my RO/DI output and lessening my waste water.
Excellent product By abi on 4/29/2013
abi would recommend this product to a friend
Great pump! My municipal water pressure was at 29 psi this pump brought it all the way up to 60 psi with room to increase the pressure! Excellent for my 150 gpd rodi water saver plus unit.
Great product By retnip on 4/15/2013
retnip would recommend this product to a friend
This is really a neat little pump, it comes with everything you would need to boost the pressure to your ro system. It boosted my pressure from 45lbs to around 90lbs. It is a little noisy and needs to be mounted to something so it dosnt walk around. Its easy to hook up, just snip out a short section of supply hose, and a short section of the hose that goes to your storage tank to insert the pressure switch. When you float rises, the pump will shut off automatically.
Works Great! By Christy on 4/13/2013
Christy would recommend this product to a friend
This works great! Bought the 75gpd RO/DI unit and when I got it set up I was VERY disappointed to find I only had about 30 psi and a periodic trickle of filtered water coming out. Purchased the booster pump and patiently (not really lol) waited for it to come so I could get rolling on curing the dry rock I previously purchased. Hooked it up and started getting nearly 100 psi!! Had to turn it back a little. Now pulling a steady 80 psi at 0 tds and have my rock curing in the basement!! :-) Next purchase might just have to be the converter kit to increase my unit to the 150 gpd now that I have the pump and know it could handle it!! :-)
great solved my low pressure problem By chen yang on 3/30/2013
chen yang would recommend this product to a friend
before the pump i was getting around 45 psi at best. after I installed this , which was super easy! I got around 95 psi. so i have to dialed down a bit to around 80 psi. i am really happy that i can finally utilize full of my ro di unit. none of the other big aquarium online store offer booster pump kit and instrucitons. thank you brs!
Time is money By greenwizard on 3/25/2013
greenwizard would recommend this product to a friend
doubled my water output.