Outstanding! By RiffeShooter on 1/17/2014
RiffeShooter would recommend this product to a friend
I purchased this with the 150GPD Water Saver RO/DI kit and I have to say, this is like adding a turbocharger to your water output! Has a consistent pressure of 85 psi and blows that water out. Another simple to install BRS product that saves the day!
Excellent value for your system By chris on 1/15/2014
chris would recommend this product to a friend
Before installing this my dual membrane system was operating at about 35psi. My system was producing about 50/50 product/ waste water. After installing this booster i am operating at 70psi and my water to waste production is around 75/25 product/ waste water. This thing is a must have if you want the highest efficiency possible out of your system.
Boosted PSI By Adam on 1/8/2014
Adam would recommend this product to a friend
My house has fairly low water pressure, around 40 PSI or a little under most of the time. I purchased this pump and now I am getting around 85 PSI. This will be perfect for when i order the 150 GPD upgrade for my RODI.
Excellent product By WingRider on 1/6/2014
WingRider would recommend this product to a friend
Added at same time I installed the 150g per day kit. Pump is quiet and pressure switch shuts the pump off once float Valle is triggered. Can tell difference in flow rate and hope to see waste drop off resulting in lower water bill.
highly recommend By steve on 12/16/2013
steve would recommend this product to a friend
Love this pump !! Im running a 150g per day 5 stage rodi unit...this pump boosted my water pressure from 40 psi to over 90 psi...i dialed it back to 68psi and all is happy. This pump is very quiet and the kit has everything you need to install it...maybe order some extra tubing depending where you put it.
Works Great By Christopher on 12/12/2013
Christopher would recommend this product to a friend
Neede this pump due to low water pressure. pushed pressure from 35psi to 88psi. Runs very quiet. Great product.
Booster pump By Bulldog on 12/12/2013
Bulldog would recommend this product to a friend
Great pump quiet and doubled my water pressure.
Great Product By Jennifer on 11/26/2013
Jennifer would recommend this product to a friend
Hooked this up in minutes and it took my psi from 40 to 90. Took it from a trickle to a strong stream. Fills my holding tank at least 3 times faster. I live in a small town that has water with tons of crud in it was burning threw DI resin. Before I would have to change resin after filling my holding tank which holds about 30 gallons after 3 times. Now I have so far filled it 4 times and only about 1/4 of the resin had started to change color.
Great Water Pressure By Sherman on 11/26/2013
Sherman would recommend this product to a friend
I have a well for our water system and the pressure has never been very good so when I added my 75 GPD RODI system on it, which had a pressure gauge, I was surprised that it showed I only had 20 psi, so I bout the Aquatec 8800 and my pressure went up to just over 90 psi. I use to fill my 55 gal resureve over a period of several days, now I get a gallon in about 30 min.
Performs as advertised By Geoff on 11/22/2013
Geoff would recommend this product to a friend
The pump saved on DI resin and it created enough pressure to send product water horizontally 30' and vertically 12' to my ATO reservoir at a rate of 3 gallons per hour. I'm very glad that I bought this pump!
Simple and effective By Ken on 11/14/2013
Ken would recommend this product to a friend
I live on a well, 35-55 psi cycle. Attached the pressure gauge (sold separately) before the membrane and only 30 psi. Hooked up the pump, 5 minute job, and now I'm at 80 psi going into the membrane. Output went from a trickle to nice stream. Will be interesting to see how long it takes to fill my 25 gal WC container this weekend. At the tap for our drinking water the flow is more than doubled. Excellent product.
works great By Ed on 11/7/2013
Ed would recommend this product to a friend
I have about 37 psi out of my faucet, and made 1 gal about a half hour or more , now it's at 80 psi and 1 g a l in. About 15 minutes. My concern is that the Gage was going up to 90 psi as. I went along making water. I turn it down to 60. I don,t know which numbers I should watch, the outer numbers or the inner ones ?? Otherwise I'm very satisfied.
A must have By Sven on 11/7/2013
Sven would recommend this product to a friend
My Tap water pressure was running about 40 PSI. Ever since I bought this and adjusted my PSI to ~70 PSI I now produce product water 2-3 times faster... and my DI Resin lasts longer as well!
Works great By Chuck on 11/4/2013
Chuck would recommend this product to a friend
This is just what I needed. I had a little over 37psi before I added this pump. I am now running at about 80psi now. Works great.
Great Investment to a RODI system By Kha on 11/2/2013
Kha would recommend this product to a friend
I had 45psi on my 75gph + 150gph upgrade RODI system until I added this pump. My psi is now 82-ish. Working great so far! Very easy to assemble and BRS already has a video on the installation (not that you would really need it). The pump makes some noise (very little) and vibration as all pumps do. The bracket seems to help out a bit. Not very concerned about the noise level since its going to be installed in a basement/ garage area. Wished the transformer had mounting hardware for the wall as the RODI and booster pump does. It has 4 rubber feet that sits on a horizontal surface. Not a big deal and not worth dropping any stars.
A MUST HAVE!!! By Megan on 10/18/2013
Megan would recommend this product to a friend
A must have!!! Nice to see the water quicker!! Life saver
What took me so long! By Turf on 10/15/2013
Turf would recommend this product to a friend
This is awesome, consistent 80psi to my filter so everything works unbelievably better, faster and more consistent. Wish I bought this years ago.
Stop what you're doing and BUY THIS UNIT NOW By Carlos A. on 10/6/2013
Carlos A. would recommend this product to a friend
I've been frustrated to no end trying to fine tune a similar setup I bought from another vendor. Their unit included the same pump but didn't include a pressure switch and instead required the endless fine-tuning of several different variables (turn this dial down, turn the other up, but not too much, etc...), which took hours and hours and it never ever came even close to working as well as this did right out of the box. This is a set-it-and-forget-it solution that is SO MUCH EASIER. I had thrown away my previous set up and I am so glad I bought this one. My 150 gpd RO system went from producing a very slow drip (maybe 25 gallons/day) to now producing a solid stream of very close to the 150 gpd max. More importantly, the ratio of good to bad water is much better. Buy this now. It's the same kind of quality you find with Tunze and Bubble King.
I highly recommend combining this with the: Aquatec Auto Flush Flow Restrictor, also available on this site. That makes it truly an automatic system that will save you tons in filters and water over the long run.
Aquatec is brilliant for having designed this. Bravo.
excellant value and a must have time saving pump By happy reefer on 10/6/2013
happy reefer would recommend this product to a friend
llike everyone else I had low psi only 40 going into my 5 stage brs ro/di unit and only making 2 gallons of water at about 35min a gallon and replacing resin at a quicker rate then I would think should be needed so my descision became a cost saving idea to finally purchase so I lucked up it just so happen a fellow Michigan reefer was selling one for $70 with power supply and pressure switch so it was a no brainer when I offered a trade and only spent $50 and with the rubber feet you cant really here it running I went from psi of 40 to 60 and with the adjustment screw I now have 80 psi and producing 1 gallon every 15-18 min 0 tds water
Great Product By Brian on 9/10/2013
Brian would recommend this product to a friend
I was ripping through DI resin like crazy. With the addition of this pump, I get much more life out of my resin.
A must for any RODI system By Timothy on 9/3/2013
Timothy would recommend this product to a friend
The Aquatec 8800 booster pump is a must for any RODI system. I had adaquate water pressure half of the year before adding the pump- now I am making water at my systems capacity more efficiently even in the winter. The pump will pay for itself over time and is easy to integrate into your current system.
Problem Solver! By Mark on 9/1/2013
Mark would recommend this product to a friend
Water pressure out of the tap was 25-30 psi. Not good, Ordered this kit from BRS and now I'm at 63 psi with plenty of room to spare. Problem solved and the best price.
A must if you have your own well By Tom T on 8/7/2013
Tom T would recommend this product to a friend
I live in the country with my own well. I connected my RO/DI system and the pressure swing between 24 and 32 psi. I added this pump and now my pressure is between 88 and 90 psi. This has increased the my RO/DI water output tremendously.
Need a boost By Little man on 8/6/2013
Little man would recommend this product to a friend
I got the aquatec 8800 kit from brs I hooked it to my brs ro di system and what a difference it made . My water pressure went from 35 psi to 95 psi . Also my brs di resin last longer now. I also got the pressure switch and float valve which took the guess work out when my water storage container was full . No more check every hour to see if it is full. It shuts the pump off automatic when it reach a certain level. Thanks brs for making reefing easier