Great product, increased my water production greatly By Jared on 7/8/12
Jared would recommend this product to a friend
Up until recently I relied on my household water pressure to run my RO/DI system. At only 40-55psi max it would take roughly an hour to make one gallon of product water. I made this purchase and have never looked back; I can't believe I waited so long for this. I have been running my system for almost 2 years before I made the leap and purchased the booster pump. I have went from producing 1 gallon an hour to 3.5 an hour. The waste water volume has also reduced along with the time interval it takes for my DI resin to exhaust. The volume of water that used to take me two and almost 3 three days now takes less than one. I can't express how delighted I'm for this product.
Well worth the money By Terry on 5/31/12
Terry would recommend this product to a friend
I had to get this because our water pressure was only around 26lbs.
So glad we did! The only issue i had with it. Was the vibration, it would shake the water line pretty good. Which I solved by placing some foam tubing over it.
Great Pump! By moore1811 on 5/24/12
moore1811 would recommend this product to a friend
Although a tad pricey for my taste I happy with the quality of the product. It did it's job and boosted my very poor water pressure to a hefty 75psi with no problem. Now I can use the 150GPD upgrade with maximum efficiency.
Must have pump By Ben on 4/12/12
Ben would recommend this product to a friend
Recently added this pump to my 5 stage RO/DI with dual 100 GPD membranes and I had pretty decent pressure at 60 PSI, but I added this and wow did it make a difference. I now make water at almost 270+ GPD a day. 40 gallon tank is filled in 3 1/2 hours!!!!
great pump By Clinton on 3/22/12
Clinton would recommend this product to a friend
This pump is soo nice. Since Im on a well and my water pressure was to low my ro unit was not running efficiently. But now its running great. I would recommend a prefilter so you don't ruin the pump
great efficiency addition By Byron on 3/21/12
Byron would recommend this product to a friend
we're now on a well with marginal pressure -- this (pricey) booster brought our efficiency up a bunch!!!!! wish it was cheaper, love what it does for me...
Works amazingly well with AWI Typhoon RODI By Shawn on 2/23/12
Shawn would recommend this product to a friend
I have the Air Water Ice Typhoon Extreme III RO/DI system. It worked *ok* on city water pressure around 35-40psi. I've since moved to my new house where my well water pressure is only around 25psi and the RO/DI output is awful. Admittedly, I needed to change the RO filters, but it took THREE hours to fill a 5 gallon bucket….Three hours!!! I knew a booster pump was definitely needed.
I was considering the pump that AWI sells, but heard mixed reviews so I tried this one given the great reviews here and on all the saltwater forums. I’m glad I did!!! This baby is sweet. Super easy to setup and the pressure switch works perfectly for shutting off the pump when my ASOV kicks in. You can barely hear it running too.
The AWI RO/DI I have says that you shouldn’t go above 75psi so I was able to fine tune the pump (using adjustment screw on top) to give me 70psi and the water production rate is SO much better. The most satisfying test is just turning the pump off and seeing how pathetic the flow rate into your holding container is! Then plug it back in and watch the water start streaming out!
The rejection rate also seemed to get better too. I don’t have exact percentages because I forget what my well water TDS was to start with…but I can say that my TDS out of the RO membrane fluctuates between 1 or 2 WITH the pump. Without the pump, I was getting 4-6 pretty consistently. Naturally it is 0 out of my DI…but the lower the TDS is on the input to the DI, the less money you pay in DI replacements!
AWESOME!!! A MUST FOR LARGER RODI SYSTEMS By spotter on 2/20/12
spotter would recommend this product to a friend
I just added this to my system when I upgraded from 75 gpd to 150 gpd. My pressure was just under 55 psi and I split my rodi output line in 3 different directions. I would never be able to fill 3 different containers at the same time...until now that is. With the booster pump my psi gauge is full throttle and I can fill all 3 containers at the same time when needed. You won't regret this investment.
Well worth the investment! By Collin on 2/17/12
Collin would recommend this product to a friend
Before I installed this my house was pressurizing the input at 45psi which ended up meaning that the RO/DI 5 stage was producing 37 gallons per day, way below optimum.
After installing the pump I was producing water at 72 gallons per day, extremely close to the touted 75 GPD for the RO/DI sold on BRS.
See my full review with pictures at:
Great addition to RODI system By Kevin on 2/16/12
Kevin would recommend this product to a friend
I had an inlet pressure of 42 psi. I added this kit and my inlet pressure went to 94 psi. It makes RODI water fast and it is relativly quiet. easy to install and use. Worth the money
Able to expand with Aquatec 8800 By Jim on 1/30/12
Jim would recommend this product to a friend
My faucet pressure is only 22psi and when I first installed this pump I was getting 92psi to the membrane! I easily adjusted the pressure to 63psi. I would'nt have believed the improvement with my 75gal 5 stage+ if I had not seen it for myself. The pump is also very quiet running even though I run my system on the countertop.
Great unit but be ready to adjust By Doug on 1/23/12
Doug would recommend this product to a friend
Watched the video for installation and BRS said the pump and pressure switch are adjusted from the factory so no adjustment is usually necessary. I hooked everything up and the booster pump went over a hundred psi so I had to back it down. Then tested the pressure switch and at about 90 psi it was still going strong so I had to adjust that as well. Now that everything is adjusted properly its working like a charm. Love it!