A Must Have By Dave on 9/5/2014
Dave would recommend this product to a friend
If you are running RO/DI you need to know what your pressure going into the unit is, so as to optimize your units performance. This gives you that information. Wish I had it from the beginning. I only knew that I had decent pressure, but then again I was guessing as I was wrong. No I know and it's working better than ever.
You need this! By William on 7/26/2014
William would recommend this product to a friend
I wasn't getting the best production out of my RO/DI unit. I replace the filters and still not great. I purchased this inexpensive product and found that i didn't have great pressure. This works great and save you money.
air filled pressure guage By nicholas on 2/9/2014
nicholas would recommend this product to a friend
works for knowing the pressure going to your RODI unit. But go with the liquid filled if you are running it right after a booster pump. if it is anywhere else in the line you are good.
Simple and affordable By Michelle YV, CA on 12/15/2013
Michelle YV, CA would recommend this product to a friend
Nice little pressure gauge, It's affordable and easy to install
SIMPLE AND AFFORDBLE By jason on 11/27/2013
jason would recommend this product to a friend
VERY EASY TO INSTALL AND GIVES YOU A ACCURATE PRESSURE READING. I HAD NO CLUE MY WATER PRESSURE WAS ACTUALLY AS GOOD AS IT WAS. I WAS GOING TO BUY A BOOSTER PUMP HAD I NOT GOT THIS DEVICE AND BOY WOULD I HAVE FELT DUMB....
Works perfect By Bill on 9/26/2013
Bill would recommend this product to a friend
Easy to integrate with my RO/DI system. Works as expected.
Good buy By Chris on 8/2/2013
Chris would recommend this product to a friend
It's very easy to install and works great. I ordered it from Canada and it was painless. Ordered it on a Thursday and received it on the following Thursday. Very happy with the service.
It is what it is By David on 7/17/2013
David would recommend this product to a friend
Do you need to know your pressure. Bam! this does that. Easy to read and set up.
Works great! By Matt on 5/16/2013
Matt would recommend this product to a friend
This one was to replace my stock one on my BRS system. Works perfectly, although with the booster pump it does shake the needle back and forth some within 5 psi due to the pressure load.
Must have for any rodi unit By Anthony on 4/12/2013
Anthony would recommend this product to a friend
Not only is is easy to install but is beneficial for proper use of your unit to determine if new filters are needed by pressure dropping lower than average
Wonderful By Timothy on 9/10/2012
Timothy would recommend this product to a friend
No complaints. Get's the job done and let's me know what the pressure is going to my BRS RODI unit.
Good tool to have By Jeffrey on 7/4/2012
Jeffrey would recommend this product to a friend
I have this installed right before the RO membrane and tells me the PSI of source water going into the membrane. If the pressure drops too low than average then that would tell me if there is a clog/damaged hose line or either sediment, carbon, chlorplus are in need of a change.