Awesome! By TxAdamFitz on 11/11/2013
TxAdamFitz would recommend this product to a friend
Works as expected. Install was easy. Kit was inexpensive. No more mopping up the RODI room!
Great product! By Greg on 10/27/2013
Greg would recommend this product to a friend
Very easy to install and works perfectly.
good but leads to rapid cycling By drsalomon on 10/14/2013
drsalomon would recommend this product to a friend
It is a reliable, good starting valve but will rapidly cycle your RODI system when your ATO slowly draws water. This may lead to decreased lifespan of RO membrane. Better would be an actuated solenoid triggered on with low float valve that stays on until a more highly placed second valve shut's it off. My system needs to have a booster pump and the rapid cycling during ATO drawdown is very harsh on the RODI system and my membrane prematurely died.
Perfect By Cameron on 10/5/2013
Cameron would recommend this product to a friend
Definitely a good buy. Don't have to worry about forgetting to check if my container is full. Super easy to install just drill 1/2" hole.
Should have gotten it long ago By David on 10/2/2013
David would recommend this product to a friend
The product was exactly as advertised but comes with no instructions. Easy enough, you just drill a hole in the side of the intended storage container for the RO/DI water at the level you want. Insert float, attach the washer and connector to the RO/DI output line and presto. No more watching a timer or overflowing onto the floor. Making water is now so easy I don't even think about it.
4 out of 5 because of the lack of instructions.
Simple with quality By salt135 on 9/15/2013
salt135 would recommend this product to a friend
Easy to install and simple to use, a no brainer.
BUT, I would like the float to drop to it's lowest position before allowing water to flow. I have a 2 gallon fresh water make up tank with RODI water and would like it to empty mostly before triggering the refill.
In it's use now I close the fill valve leading to the float and let the tank empty before refilling. The float acts only to prevent the 2 gal tank from overflowing. That's good but...... When on vacation and friends are watching the tank, I leave the valve open and the 2 gal is always filled. I guess that's good enough for low tech!
Great product By Todd on 9/15/2013
Todd would recommend this product to a friend
could not be easier to install.
Non adjustable float valve.... By Frank on 9/11/2013
Frank would recommend this product to a friend
I purchased the standard float valve along with my 5 stage RO/DI unit. The valve is simple and robust.
Drill a hole in container, inset with included rubber washer into container, tighten nut, install RO line and DONE!
Not everything in reefkeeping has to be hard.
Save yourself the headache and get it By Mike on 8/15/2013
Mike would recommend this product to a friend
I finally got around to picking up a few of these after one too many floods. I have 1 installed for my auto top-off and another in a container I'm using to mix my salt water. It takes only a few minutes to install.
Awesome By Kyle4201 on 8/12/2013
Kyle4201 would recommend this product to a friend
I thought I was buying the adjustable one, but the reg one works just fine. I bought my 1st R/O unit and I had no doubt in my mind I was going to get 1 of these. I had plans for a toilet tank flow stop rig untill I saw this. Great time and life saver
Essential Purchase forWater storage By Craig on 8/4/2013
Craig would recommend this product to a friend
I bought the non adjustable version. This was easy to install on my water storage tank and it works as advertised. Product shipped safely with no issues
Necessity By Sal on 7/21/2013
Sal would recommend this product to a friend
Without this you couldn't sleep at night, or wake up to a basement full of water.