Float Valve By dan on 1/29/2014
dan would recommend this product to a friend
Why Wait By Patrick on 1/25/2014
Patrick would recommend this product to a friend
I had always put my RO in a five gallon bucket as I needed it. It always took a couple of hours in which I would set a timer to remind me to shut it off. I was still always overflowing my bucket wasting water and filter capacity, but in a safe place so the water just went down the drain. $$
I bought the float for a new 35 Gallon storage tank. All I needed was the float valve since the BRS RO System I bought already had the shut off valve and check valve. Drilled a small hole in the storage tank and mounted the float, tested...and then turned on the water and left and let the tank fill. The water turned off as expected.
I should have bought this years ago for my five gallon bucket.
No more worries By Mario on 1/23/2014
Mario would recommend this product to a friend
This has given me a great piece of mind. No more worries of water being all over the floor.
As expected By Red7Xero on 1/21/2014
Red7Xero would recommend this product to a friend
Easy to install and works exactly as expected. It really couldn't be any easier to install or use. I recommend this to everyone who uses a RO/DI with an ATO system.
Does what it should By Tanner on 1/13/2014
Tanner would recommend this product to a friend
The float switch takes less than a minute to install and does what it is supposed to. I have only had the switch for a few weeks so I can't speak for its long term effectiveness.
GREAT PRODUCT! By Marty on 1/11/2014
Marty would recommend this product to a friend
As all other reviews got this product before I would have forgotten the water was filling my storage container. Easy to install its a must with RODI systems.
get the job done By Michael on 1/8/2014
Michael would recommend this product to a friend
This guy saved me a lot trouble on guessing if my RO are filled, had a few minor flood before I installed them, now I can just let the water run and forget about it! Works flawlessly with BRS RO units.
Smallest Footprint Float Valve By Adam on 1/8/2014
Adam would recommend this product to a friend
I have very limited space in my sump and this float valve fit perfectly due to its smaller size. It has been going string now for a year.
Easy choice By eric on 1/5/2014
eric would recommend this product to a friend
Easy installation, made with quality materials and seems to be durable.
Great By Dustin on 1/2/2014
Dustin would recommend this product to a friend
I love it, should have bought one years ago. Just with I had a diagram when installing it. it looks simple bout one part in the wrong place would be bad. I had to watch the brs video to see how it its installed correctly
A Must Have With Any RO/DI Unit By Tyler on 1/1/2014
Tyler would recommend this product to a friend
Just drill a small hole into your water reserve, mine being a brute trash can and you never have to worry about it overflowing. If you want to go out all day while your unit is running you will never have to rush home to turn it off. Every ro/di unit should have one.
Does its job By christopher on 1/1/2014
christopher would recommend this product to a friend
These float do there job and shut off water when full and add when empty or as needed!
Piece of mind By Rich .k on 12/21/2013
Rich .k would recommend this product to a friend
This product works exactly as described. It keeps a disaster from occurring if you forget to shut your RODI system off.
Awsome Product By Zach on 12/19/2013
Zach would recommend this product to a friend
Worked great with RO/DI unit hooked up to storage tank. No need to watch your RO/DI unit with this product and the right RO?DI unit. Shuts off water when tank is full and no worry of forgetting to shut off RO/DI unit anymore.
Works By Michael on 12/16/2013
Michael would recommend this product to a friend
12 bucks for piece of mind? A bargain! I did not purchase the valve that allows the Rodi to turn itself back on....I didn't see it when I placed my order unfortunately.
Definitely a good buy By Russell on 11/24/2013
Russell would recommend this product to a friend
I have got, I think about 4 of them, one in my food room, two on my holding tanks, and two on my storage tanks love them, change that to 5, i did not get all of them from BRS, BUT i will now...
Awesome! By TxAdamFitz on 11/11/2013
TxAdamFitz would recommend this product to a friend
Works as expected. Install was easy. Kit was inexpensive. No more mopping up the RODI room!
Great product! By Greg on 10/27/2013
Greg would recommend this product to a friend
Very easy to install and works perfectly.
good but leads to rapid cycling By drsalomon on 10/14/2013
drsalomon would recommend this product to a friend
It is a reliable, good starting valve but will rapidly cycle your RODI system when your ATO slowly draws water. This may lead to decreased lifespan of RO membrane. Better would be an actuated solenoid triggered on with low float valve that stays on until a more highly placed second valve shut's it off. My system needs to have a booster pump and the rapid cycling during ATO drawdown is very harsh on the RODI system and my membrane prematurely died.
Perfect By Cameron on 10/5/2013
Cameron would recommend this product to a friend
Definitely a good buy. Don't have to worry about forgetting to check if my container is full. Super easy to install just drill 1/2" hole.
Should have gotten it long ago By David on 10/2/2013
David would recommend this product to a friend
The product was exactly as advertised but comes with no instructions. Easy enough, you just drill a hole in the side of the intended storage container for the RO/DI water at the level you want. Insert float, attach the washer and connector to the RO/DI output line and presto. No more watching a timer or overflowing onto the floor. Making water is now so easy I don't even think about it.
4 out of 5 because of the lack of instructions.
Simple with quality By salt135 on 9/15/2013
salt135 would recommend this product to a friend
Easy to install and simple to use, a no brainer.
BUT, I would like the float to drop to it's lowest position before allowing water to flow. I have a 2 gallon fresh water make up tank with RODI water and would like it to empty mostly before triggering the refill.
In it's use now I close the fill valve leading to the float and let the tank empty before refilling. The float acts only to prevent the 2 gal tank from overflowing. That's good but...... When on vacation and friends are watching the tank, I leave the valve open and the 2 gal is always filled. I guess that's good enough for low tech!
Great product By Todd on 9/15/2013
Todd would recommend this product to a friend
could not be easier to install.
Non adjustable float valve.... By Frank on 9/11/2013
Frank would recommend this product to a friend
I purchased the standard float valve along with my 5 stage RO/DI unit. The valve is simple and robust.
Drill a hole in container, inset with included rubber washer into container, tighten nut, install RO line and DONE!
Not everything in reefkeeping has to be hard.