Overflow By Ty on 3/6/2015
Ty would recommend this product to a friend
I was abit uneasy about hooking up a overflow to my 60gal (never worked with pvc before) But it was a breeze, and the CS90 has worked like a champ. Not loud at all and skims water great. Thanks to BRS for the great product!!
no Better service, no better product. Thanks BRS!!! By Trinnium on 2/26/2015
Trinnium would recommend this product to a friend
If you need an over flow box, this is the one to get. If you’re not sure where or whom to perches it from, then someone has failed to direct you to BRS!!!. Amazing product!! Amazing service!!, that sums it all up. O yea!! I am real person like you, not someone that works for them or computer generated:). Just saying :).
Does its job By Sean on 2/16/2015
Sean would recommend this product to a friend
It works like it is supposed to and its the only option I have now. But it is a little big and requires a lot of room behind the aquarium.
good product By Ken on 1/26/2015
Ken would recommend this product to a friend
If you are not able to get a pre-drilled tank these are great products. You can regulate the flow from the return pump and make it virtually silent. It can be difficult to clean but I have only had to do that on a few occasions. This is my second CPR overflow, the first was 10 years old and I had no problems with it, I damaged it moving my 75 to another room so this is a replacement. The aqualifter, I can take it or leave it. I was using a MaxiJet 1200 with the same results plus the added benefit of additional current.
lifter pump runtime By Greg on 12/22/2014
Greg would recommend this product to a friend
If you are worried about the lifter pump failing after it has run so long it dies (I read this concern), what you can do is put a refractometer in line with the tubing. You could probably use a Smart ATO, and if it senses a refraction due to salt water it will be off, If the refractive index is that of air, it will turn on. Much like it behaves in a sump turning on an auto fill cycle. Seems like a lot of trouble though. The lifter pump is a safe guard against air pocket build up in your overflow and is not necessary for the overflow to run. It is a safe guard and certainly recommended. Much better than U-tubes.
CS90; The perfect HOB overflow By Greg on 12/21/2014
Greg would recommend this product to a friend
Installed a CS90 w/lifter pump. Plugged it in. Done. Perfect. I too got a little gurgling at first however, then increased my flow to hold at about an inch above the head of the filter guard on the intake. Silent.
Excellent By Roger on 11/20/2014
Roger would recommend this product to a friend
I've had this overflow for almost a year now. It works flawlessly. Easy to assemble and use.
Great Product By Bill on 9/7/2014
Bill would recommend this product to a friend
I have been useing this over flow for about 8 years. I just replaced it because the nipple for the vaccume pump broke off. I have never had a siphon break in all those years. When the power goes off, it starts up quickly and resumes the flow. If you do not have a drilled tank, get this product
quality product By Eric on 7/26/2014
Eric would recommend this product to a friend
Purchased this because I cannot drill holes in my tank. I was nervous when buying this because of it possibly failing, but it has been running constantly with no issues. When power goes out it drains into sump and when power comes back on the siphon restarts and works just like it should.
Good By Victor on 3/11/2014
Victor would recommend this product to a friend
I have the CPR102 on my 75 gallon with 40gal sump. I like how quiet it is, it does need a little tweaking to get it quiet My Skimmer is louder than this
Does the job By Reefer368 on 3/4/2014
Reefer368 would recommend this product to a friend
I have the cs 150 for my 125 gallon tank and 40 gallon sump it is awesome except for the fact that my system is hard plumbed and it is pretty loud with the gurgling of the water
Works great very happy with it! By Jorge on 2/24/2014
Jorge would recommend this product to a friend
We are very happy with our choice and would say no problems at all with it.
CS90 Great product By O'D on 2/5/2014
O'D would recommend this product to a friend
I originally went the cheapest/ugliest route and constructed overflows out of PVC via DIY videos on YouTube. While they were indeed cheap, functional, and gave a sense of accomplishment, it just didn't look good, and brought a constant fear factor knowing the flaws of that system. I was toying with the idea of drilling the tank, but soon decided a HOB overflow would be the safest route. These overflows are great, but I would like to know how long the pump will last until it burns out...while the siphon remains despite the pump being turned off (or if it died), if the power goes out and then comes back on and you're not there to start the siphon again, you could easily flood the tank and cause big problems. I would definitely say the pros out weigh what little cons there are with this. I'm not having any noise problems, but if you do, there are videos for standpipes to help with this.
Not Happy By shawn on 12/20/2013
shawn wouldn't recommend this product to a friend
first of all, not thrilled that you have to add a siphon pump to make this thing work! Second if you hard pipe the unit it is very loud.All the adjusting in the world wouldn't stop the gurgling. I had to make two pipes that fit into the drains (thank god for you tube). Overall i don't think i would not recommend this to anybody that wants to hard pipe their systems.
Good option By Daniel on 9/19/2013
Daniel would recommend this product to a friend
If your tank is tempered like mine and you don't have a reef ready design, this is your best option. Just make sure you establish a water level for both your tank and sump. If either your siphon fails or your pump turns off you could have an overflow in your tank or your sump [double trouble]. Also be sure to use a good ball valve or two on your lines to regulate flow... It makes a bit too much noise, and the pre-filter will clog eventually, so do your maintenance, and this will work well for you....
Best alternative to a drilled tank By Tim on 5/2/2013
Tim would recommend this product to a friend
I've been running this set up for about a year. As other reviewers have noted, the aqua lifter pump maintains and restarts the siphon even in the event of a power outage. So far, I've had no problems. A couple of notes: 1) As an added precaution, I drilled a 1/8" hole in my return just below the surface of the water. In the event of a power failure, this will stop the return from back-siphoning into the sump and overflowing it; 2) If you have the proper sized sump for your tank, you can tinker with the water level in the sump, keeping it low enough to accommodate water flowing back from the tank if the power fails. Nothing is fool- or idiot-proof, but if you follow the instructions and do the maintenance, this is the next best thing.
Deluxe CS50 with Lid By Chavinpat on 4/8/2013
Chavinpat would recommend this product to a friend
Solid craftsmanship. It isn't as loud as I thought it would be, just keep the cover on. Like many equipment, regular maintain is a must.
CPR CS90 Overflow w/ Pump By Christian on 3/21/2013
Christian would recommend this product to a friend
I love this combo. Gives me peace of mind that my overflow siphon will always be going, even if power stops and it has to restart. This unit is exceptionally quiet, but I may add a durso standpipe to mine.
Excellent product! By Pat on 11/27/2012
Pat would recommend this product to a friend
This is probably the best option if you cannot drill your tank. I tried numerous scenarios to try to break the siphon and was unable to do so. Just make sure the outlet hose from the Aqualifter is under water either in the tank or the sump and you won't have a problem.
Very easy installation By Pat on 11/27/2012
Pat would recommend this product to a friend
This is probably the best option if you can't drill your tank. I have tried many scenarios and I cannot make this thing lose siphon. Even if you turn off the aqualifter it keeps on flowing, just make sure that the outlet hose from the aqualifter is under water, either in the tank or the sump.
CPR 102 By Michael on 11/21/2012
Michael would recommend this product to a friend
I've got it on a 75 gal. It's a little over-kill. Got this one because I figured if one pipe clogged I'd still have another pipe open. We turn all pumps off twice a day when we feed. Never a problem with siphon starting. Best part is it's completely silent. If I turn off my skimmer I can't even hear the aquarium running. So Nice! I absolutely love CPR Aquatics!
Good By dtawahn on 5/6/2012
dtawahn would recommend this product to a friend
We like the product and the quietness of the flow; however, the pump worries me. If it were to fail, there would be an issue. We have not had any issues and do not have to worry about fish getting trapped.
Much better than Eshopps By john on 2/25/2012
john would recommend this product to a friend
A snail got sucked into the U tube of my Eshopps overflow and 10 gallons of saltwater ended up on our wood floor. Wish I had my tank drilled but the CPR 102 seems to be the next best thing. It is also much quieter than the Eshopps that I had modified with durso standpipes. The CPR DX overflows are plug and play.
BRS doesn't carry flexible corrugated PVC drain tubing. Made my own using 1.25" PVC spa hose found at HD. I cut to length and used PVC glue to 1" PVC piping for a leak free connection. Tried a hose clamp but that leaked. I think reinforced vinyl tubing, sold by BRS, is too stiff for this application and corrugated PVC tubing allows the return water to become more oxygenated.
I'm not a fan of using the foam filters that came with the CPR. I couldn't hear a sound level difference and foam filters can harbor algae which will add nitrates to a tank, if not regularly cleaned. Most reefs would have a sock filter where the return water enters the sump anyway.
Also bought a Ultra Float Switch (Ultralife Reef) that I'll mount in my sump to kill the main pump if the sump water goes too low, in the event that the lifter pump dies and I lose siphon (note to BrentB). BRS, you should carry these too. Making one from parts, sold by BRS, looks like more effort than necessary.
If you have a U tube overflow box, I would recommend replacing it with a CPR. Also having a low water kill switch in the sump would be a good idea.
Works great By James on 2/23/2012
James would recommend this product to a friend
This product works great, and looks great also. My only complaint would be its pricey for it being such a simple thing. But hey someone hasta make money.