Just finished assembly By Robert on 4/1/2017
Robert would recommend this product to a friend
It went together fast, no problems. I used a tupperware 3/4 gallon container with a relatively soft plastic top. I had no problem with the build. I have the valve down to a drop every 10 seconds, that took some time to get it regulated. I think that the valve is to large to get the drips to where I think that they need to be, however that being said, it works and with some minor mods it believe that I can even get to drip at a slower rate
Crap By Jason on 11/17/2016
Jason wouldn't recommend this product to a friend
I built just as the video, with the oxo container. Blowing does not start the siphon and the ball valve can't adjust down enough to a drip per second, it's either flowing or stopped.
Honestly, I can't believe your pushing this setup with a video. I could see someone dumping too much kalk at once into a tank, there is zero control on this setup.
Works great. By AZReefjunkie on 8/28/2016
AZReefjunkie would recommend this product to a friend
I used this to improve my ATO container. Works exactly as intended.
all the parts in one package By awesome on 5/16/2016
awesome would recommend this product to a friend
Great little DIY package. can be used to Drip Kalk, or can be hooked up to a dosing pump and used as a dosing container.
Pretty good product By Rich on 5/2/2016
Rich would recommend this product to a friend
Getting all these fittings from BRS is cheaper than going to a box store. They are quality fittings and for all those that say they don't come apart once put together, well, they are entirely wrong. They are kinda like Chinese handcuffs, you have to push in before pulling out. Maybe Ryan could do a quick video to show everyone how easy it really is. Then only complaint is the valve being difficult to get a slow drip-say around 1 or 2 drops per second. When you get it set properly you find hours later that it has to be adjusted again. But other than that there are no leaks or problems at all.
Save your money By Dave on 4/20/2016
Dave wouldn't recommend this product to a friend
This product did not meet my expectations, nor did it work as promised. I'm going to toss this and get a dosing pump.
Just what I needed all in one package. By Josh V on 4/5/2016
Josh V would recommend this product to a friend
This kit was just what I needed to convert a simple Tupperware container into an ATO top off reservoir. Worked great with the pump I got from these guys. Thanks BRS!
Good product By Jordan on 4/3/2016
Jordan would recommend this product to a friend
This is a great device for drop acclimation or dosing calc. I would buy again
Video was valuable By s S56 on 3/1/2016
s S56 would recommend this product to a friend
The instructional video made it very easy. One thing you do need to check is whatever container you choose make sire the lid is not very thick so its easy to drill or cut through. Walmart carries inexpensive gallon containers with thin screw on lids.
Working just like it was explained n Video By ReefNewbie on 2/19/2016
ReefNewbie would recommend this product to a friend
I followed each step exactly the way the video described - and nothing went wrong.
I bought two Class containers and made holes on top of one container's lid. Use the other one prepared to replace when the first one runs out.
One note: As I replace the container moving the "peeped" lid from the empty to the full - I need to blow on the shorter pipe after securing the lid. That obviously gets rid of the vacuum. No worries at all... as the water starts flowing (adjusting the valve) - I just open the lid again and reseat it. Like a charm it works... :-)