Elos Digital OsmoController Auto Top Off

Elos Digital OsmoController Auto Top Off Key Features:

• No moving parts
• Very easy setup. (System runs a 5 minutes self-diagnostic test when it is first plugged in.)
• Maintains a very accurate level, which is important in marine systems for a stable salinity level when keeping delicate tank inhabitants.
• Adapts to most aquarium/sump sizes automatically.

The OsmoController Digital uses a patent pending sensor with no moving parts as the first measure of the water level in the sump. Most other systems will use multiple float switches or sensors to act as back up to the initial float switch; Elos does not.

To provide an adequate fail-safe the OsmoController Digital uses a small microprocessor in combination with a patent pending sensor to control the pump and monitor the top off of your system. In the event of a fault such as an empty reservoir, a damaged pump or kinked tube, the microprocessor will recognize this and a red alarm LED will indicate the problem while stopping pumping until the problem is fixed and the controller can be reset. The OsmoController Digital also has a manual top off button that can be used to use the system as a pump for occasional water changes and to fill a container with RO/DI water easily.

The set up of the OsmoController Digital is very simple. It works with most sumps without the need for programming and the sensor design has a built in buffer for waves and small changes in the sump that will normally cause a top off system to unnecessarily top off, which will shorten the useable life of the top off pump.